What is the proper procedure for replacing a failed drive in the DS-2BCR under Raid 1 configuration? Do I need to move the good drive into a specific bay? Does the enclosure need to be powered off? Does any of this matter?
What is the proper procedure for replacing a failed drive in the DS-2BCR under Raid 1 configuration? Do I need to move the good drive into a specific bay? Does the enclosure need to be powered off? Does any of this matter?
@deypanszaekhfcatfy Check my post (2nd) in this thread. It may be advantageous to backup the data before attempting to rebuild the RAID. How to rebuild depends on if the RAID is hardware or software and, otherwise, the "good" drive is taken to be the one in bay one after determining and removing the "bad" one. A replacement drive must match the original two drives.
