@Vergil Beers The S/N should be on the box.

@PseudoPsyche This drive may run hotter although it is fine up to 80C or more. The 970 EVO Plus is known to run hot. For normal use you should be fine.

@Isab @Sabrent The Problem with "generic JMicron SCSI Disk Device" instead of "SABRENT..." is that Acronis True Image will not work anymore so this could be a big issue for some customers! S...

I am trying to register this M.2 drive and its asking for a serial number. I have already installed the drive which is now under my graphic card and heat sink... which took me forever to take off. ...

I just bought a EC-SSD2 and a SB-RKTG-4TB on amazon prime day. I was trying to clone my boot drive which is a WD 1TB drive to the SB-RKTG-4TB using the EC-SSD2. It worked great but now I have a u...

I am trying to register my EC-SSD2 and it's asking for a serial number. I can't seem to find it on the device.

Yes, sorry, that's more my question: will using the mothboard's M.2 heatsink see any possible issues with performance for this drive? I get the impression this drive will likely run hotter than my ...

@David Keenum Hey David. Upfront I will say that the cloning procedure will not work if there are any corrupted sectors since it clones sector-by-sector. Chkdsk may be able to help here, or a full ...

@Sabrent That did the trick, thanks.

Just recently bought a EC-HD2B drive dock.  Decided to test out the drive clone option.  I followed the cloning procedure in the manual, but, the clone only did the first partition. ...

@Stefano Distefani This won't work for 3.5" HDDs on this adapter.

@Stefano Distefani Correct, 3.5" is not accepted since USB only provides 5V power.

@Mark Murfitt Make sure the power adapter is attached and plugged in, plus that the power button is on. The drives will then appear in Device Manager and usually Disk Management. They will not show...

@PseudoPsyche I'm not sure what you mean width-wise. It looks like you can use the motherboard's M.2 heatsink just fine with our bare (label-only) drive. The heatspreader is optional.

I think I found the problem myself. The cable does not accept 3.5" hdd ???

I have similar problem with EC-SSHD I purchased this Sabrent model EC-SSHD adapter cable last year because it came with licensed Acronis True Image disk cloning software. The software worked great...

I purchased this Sabrent model  adapter cable last year because it came with licensed Acronis True Image disk cloning software. The software worked great last year but I'm trying to use it ag...

Hi, I've just ordered, and had delivered, this product, I have two drives plugged into two of the slots, but when I switch it on my pc doesn't pick it up. Is there any setup? I've had a look at t...

Hi, I'm considering picking up the 2TB Rocket 4 Plus G, but my motherboard has a built-in, non-removable heatsink around its M.2 slot that also does not have enough clearance width-wise to fit the ...

@Hemant Kumar Magic Leap-2 Ethernet-to-USB adapter support is dependent on their software. You'd have to ask them about any specific chipset. Our USB-C to 5GbE adapter uses the Acquantia (Marvell) ...